 | |  | |  | |  | |  |
Use T-Brace
with Sawhorses
with Sawhorses
How to use T-Brace with Sawhorses
When setting T-Braces up, gather lumber to be used - example: 2x10x16 and
2x6x16. Place saw horses 14 feet apart. Position 2x10 on saw horse leaving about 1
foot hanging off each end of the saw horse.
See Figure 1.
2x6x16. Place saw horses 14 feet apart. Position 2x10 on saw horse leaving about 1
foot hanging off each end of the saw horse.
See Figure 1.
Figure 1
Slide three T-Braces upside down onto the board, with one in the center and one
approximately 1 foot from each end.
See Figure 2.
approximately 1 foot from each end.
See Figure 2.
Figure 2
Insert 2x6 through legs of three T-Braces. Secure T-Brace pins and secure the
locking mechanism.
See Figure 3.
locking mechanism.
See Figure 3.
Figure 3
Flip entire assembly over resting overhand on each end on the sawhorses.
See Figure 4.
See Figure 4.
Figure 4
Place nails or screws into the nail holes provided on T-Brace to secure boards. The board is
now secured to the T-Brace.
NOTE: All pins must be in and locked to use T-Braces.
See Figure 5 and Figure 6
now secured to the T-Brace.
NOTE: All pins must be in and locked to use T-Braces.
See Figure 5 and Figure 6
Figure 6
Figure 5
| Where You Can Find Us T Brace LLC 1350 Manufacturing Street #109 Dallas, TX 75207 (866) 454-4983 |
Look for live demonstrations at a show
near you! see schedule
Ask for T-Brace at your local lumber
yard or hardware store. If they don't
carry T-Brace ask them to contact us.
near you! see schedule
Ask for T-Brace at your local lumber
yard or hardware store. If they don't
carry T-Brace ask them to contact us.
| _________________________________________________________________________________________ Copyright © 2005 T-Brace LLC All rights reserved. Privacy Policy - Copyright Policy - Terms of Service - Help |